Lcd-Related Symptoms; Intermittent Problems - Lenovo ThinkPad X130e Hardware Maintenance Manual

Table 5. No-beep symptoms (continued)
Symptom or error
The power-on password prompt appears.
The hard-disk password prompt appears.

LCD-related symptoms

Important: The TFT LCD for the notebook computer contains many thin-film transistors (TFTs). The
presence of a small number of dots that are missing, discolored, or always lighted is characteristic of TFT
LCD technology, but excessive pixel problems can cause viewing concerns.
If the LCD you are servicing has two or less visible defective pixels, it should not be considered faulty.
However, if the LCD has three or more visible defective pixels, it will be deemed as defective by Lenovo and
it should be replaced.
Notes:
• This policy applies to all ThinkPad Notebooks purchased on 1 January, 2008 or later.
• Lenovo will not provide replacement if the LCD is within specification as we cannot guarantee that any
replacement LCD will have zero pixel defects.
• One pixel consists of R, G, B sub-pixels.
Table 6. LCD-related symptoms
Symptom or error
No beep, power-on indicator on, and a blank LCD during
POST.
• LCD backlight not working.
• LCD too dark.
• LCD brightness cannot be adjusted.
• LCD contrast cannot be adjusted.
• LCD screen unreadable.
• Characters missing pixels.
• Screen abnormal.
• Wrong color displayed.
Horizontal or vertical lines displayed on LCD.

Intermittent problems

Intermittent system hang problems can be due to a variety of causes that have nothing to do with a hardware
defect, such as cosmic radiation, electrostatic discharge, or software errors. FRU replacement should be
considered only when a problem recurs.
When analyzing an intermittent problem, do the following:
1. Run the diagnostic test for the system board in loop mode at least 10 times.
2. If no error is detected, do not replace any FRUs.
3. If any error is detected, replace the FRU shown by the FRU code. Rerun the test to verify that no
more errors exist.
38
Hardware Maintenance Manual
FRU or action, in sequence
A power-on password or a supervisor password is set.
Type the password and press Enter.
A hard-disk password is set. Type the password and
press Enter.
FRU or action, in sequence
System board.
1. Reseat the LCD connectors.
2. LCD assembly.
3. System board.
1. See important note for "LCD-related symptoms."
2. Reseat all LCD connectors.
3. LCD assembly.
4. System board.
LCD assembly.