Canon PIXMA MX882 Network Setup Manual page 13

8
Enter the access point name/network name (SSID),
then press the left FUNCTION button.
For details on how to enter characters, refer to "Character
Entry" on page 10.
• Enter the same access point name/network name (SSID) as
that of the access point on the machine.
• For details on how to check the access point name/network name (SSID), refer to the manual
supplied with the access point or contact its manufacturer.
• Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive.
• 2-byte characters are not available for entering the access point name/network name (SSID).
9
Make sure that the access point name/network name
(SSID) is correct, then press the left FUNCTION
button.
10
Select a security protocol for the access point, then
press the OK button.
• Go to either of the following steps according to the
selected security protocol.
Go to
Disable
WEP Go to
Go to
WPA/WPA2
page 13.
• When WEP 40 bit or WEP 128 bit is selected in AirPort Utility (AirPort Admin Utility),
select WEP.
• When WEP (Transitional Security Network) is selected in AirPort Utility, select WPA2-
PSK (AES).
• When the access point is set to operate in IEEE802.11n, TKIP cannot be used. Change
the encryption type to something other than TKIP or change the standard to something
other than IEEE802.11n, then configure wireless LAN settings again.

on page 13.
.
on
• When the access point is set to operate in IEEE802.11n and IEEE802.11g with TKIP set
as an encryption standard, communication is established using IEEE802.11g.
11-A WEP
1
Select the WEP key number you want to use,
then press the OK button.
• When using AirPort, select WEP key 1 in the
screen. Selecting other key numbers will disable
the connection between the machine and AirPort.
2
Press the OK button.
3
Enter the network key, then press the left
FUNCTION button.
• Enter upper and lower case letters of the alphabet
correctly. Letters are case sensitive.
4
Make sure that the network key is correct, then
press the left FUNCTION button.
Go to on page 13.
WPA/WPA2 (P.13)
Disable (P.13)