HP XP P9500 Release Note page 13

Table 19 Overview of CLI commands (continued)
# CLI command
6
YKDELPTH
7
YKEWAIT
8
YKFCSTAT
9
YKFREEZE
10
YKLOAD
1 1
YKMAKE
12
YKQRYDEV
13
YKQRYPTH
14
YKQUERY
15
YKRECVER
16
YKRESYNC
17
YKRUN
18
YKSCAN
19
YKSLEEP
20
YKSTATS
21
YKSTORE
22
YKSUSPND
23
YKWATCH
Setup procedure of 4x4x4 Multi-Target configuration with Delta Resync is equivalent to that of 4x4
configuration and 3DC Multi-Target configuration with Delta Resync except that there are some
restrictions on definition of Cnt Ac-S and 4x4 Cnt Ac-J.
Operation of 4x4x4 Multi-Target configuration with Delta Resync is same as that of 4x4 configuration
and 3DC Multi-Target configuration with Delta Resync.
4x4x4 configuration Differences from previous
version
Not applicable Not applicable
Supported None
Not applicable Not applicable
Supported None
Supported None
Supported None
Supported None
Not applicable Not applicable
Supported None
Supported After performing Delta Resync,
if the Delta Resync copy pairs
between the Primary and
Remote sites are dissolved,
EXCTG information of Cnt Ac-J
copy pairs between the Local
and Remote sites is also deleted. command with the
Therefore, issuing the YKQUERY SELECT(COND) parameter to
command to such copy pairs
causes the YKZ296E error
message to occur.
Supported None
Supported None
Not applicable Not applicable
Not applicable Not applicable
Supported None
Supported None
Supported None
Supported None
Remarks
If this situation occurs, issue
either the YKMAKE command
with the HOLD parameter to the
Delta Resync copy pairs
between the Primary and
Remote sites, or the YKMAKE
Cnt Ac-J copy pairs between the
Local and Remote sites to
re-register them to EXCTG.
Prerequisites 13