HP XP P9500 User Manual page 44

Table 18 RAID Manager Errors Related to Manual Migration Plans (continued)
Error Code
(SSB2)
2355
2362
2363
2365
2366
2368
2369
236A
236B
2370
2371
2372
2373
237C
2380
2381
2382
2383
44 Using RAID Manager for manual Auto LUN
Message
The setting of VLL is different between the migration
target volume and the migration source volume.
The migration source volume is a primary volume
of Compatible XRC.
The migration target volume is a primary volume
of Compatible XRC.
The migration source volume is a primary volume
of IBM Concurrent Copy (CC).
The migration target volume is a primary volume
of IBM Concurrent Copy.
The volume is being used as the primary volume
of the Continuous Access Synchronous pair. The
pair is in the COPY status.
The volume is being used as the secondary volume
of the Continuous Access Synchronous pair. The
pair is in the COPY status.
The migration source volume is the primary volume
of a Business Copy pair which is in the SP-PEND
status.
The migration source volume is the secondary
volume of a Business Copy pair which is in the
SP-PEND status.
The migration source volume is not installed.
The migration source volume corresponds to either
of the following causes:
1) The volume is blocked.
2) The volume is the system disk.
The migration source volume is being formatted.
The migration source volume is a command device.
The migration source volume is an external volume
specified as a primary volume of Continuous
Access Synchronous.
The migration target volume is not installed.
The migration target volume corresponds to either
of the following causes:
1) The volume is blocked.
2) The volume is the system disk.
The migration target volume is being formatted.
The migration target volume is a command device.
Required Action
None. This migration plan cannot be executed.
Release the Compatible XRC pair, and then
migrate the volume.
Release the Compatible XRC pair, and then
migrate the volume.
Release the IBM Concurrent Copy pair, and then
migrate the volume.
Release the IBM Concurrent Copy pair, and then
migrate the volume.
Change the Continuous Access Synchronous pair
status from COPY to PAIR or PSUS, or delete the
Continuous Access Synchronous pair, and then
migrate the volume.
Change the Continuous Access Synchronous pair
status from COPY to PAIR or PSUS, or delete the
Continuous Access Synchronous pair, and then
migrate the volume.
Migrate the volume after the Business Copy pair
is changed to SPLIT status.
Migrate the volume after the Business Copy pair
is changed to SPLIT status.
Install the volume or select another source volume.
Perform the following actions for each cause:
1) Recover the blocked volume, and then migrate
the volume.
2) None. A system disk cannot be used as a
source volume.
Migrate the volume after formatting is completed.
None. A command device cannot be used as a
source volume.
Release the Continuous Access Synchronous pair,
and then migrate the volume.
Install the volume or select another target volume.
Perform the following actions for each cause:
1) Recover the blocked volume, and then migrate
the volume.
2) None. A system disk cannot be used as a target
volume.
Migrate the volume after formatting is completed.
None. A command device cannot be used as a
source volume.