Hitachi XP P9500 User Manual page 93

(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
-hbaportwwn HBA-port-WWN
Use this parameter to place online all the paths connected to an HBA port
associated with a specific HBA port WWN. Only one set of values can be
specified for the -hbaportwwn parameter.
For HBA-port-WWN, specify the value of HBAPortWWN. The parameter is
not case sensitive.
To display HBAPortWWN and PathName, execute the view operation as
follows:
>dlnkmgr view -path -hbaportwwn
For details on how to execute the view operation and display the HBA
port WWN and path name, see
in Parameters (To display program information) on page
Example
The following shows an example of placing online the paths for which
the HBA port WWN is 10000000C93213BA while confirming command
operation.
>dlnkmgr online -path –hbaportwwn 10000000C93213BA
KAPL01050-I The currently selected paths will be changed to
the Online status. Is this OK? [y/n]: y
KAPL01061-I 1 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
>
-s
Executes the command without displaying the message asking for
confirmation of command execution from the user. Specify this parameter
if you want to skip the response to the confirmation message: for
example, when you want to execute the command in a shell script or
batch file.
Example
The following example shows how to place a path, whose
AutoPATH_ID is 000002, online without asking for confirmation of
command execution from the user:
>dlnkmgr online -pathid 2 -s
KAPL01061-I 1 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
>
Hitachi Dynamic Link Manager User Guide (for VMware(R))
To display path information on page 6-29
Command Reference
6-24.
6-13