Setting Up Integrated Traces - Hitachi XP P9500 User Manual

After you have set up the collection of audit log data, use the following
command to make sure that the setting has been specified correctly:
>dlnkmgr -l view -sys -audlog
Audit Log
Audit Log Category
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd
>

Setting Up Integrated Traces

When you use HDLM, the activity logs of the HDLM command are output to
the integrated trace information file(installation-drive:\Program Files
\HITACHI\HNTRLib2\spool\hntr2n.log(where n indicates a file number)) of
the Hitachi Network Objectplaza Trace Library (HNTRLib2) installed on the
remote management client.
#
For Windows 7 (x64) , Windows Server 2008, and Windows Vista (x64),
Program Files is Program Files (x86).
If a lot of integrated trace information is output, the older information might
end up getting deleted in a very short amount of time. Also, if a large amount
of integrated trace information is suddenly all output at the same time, any
integrated trace information that is overflowing the buffer might not be saved
into the integrated trace files. To save as much information as possible,
change the settings for Hitachi Network Objectplaza Trace Library, increasing
the integrated trace file size and buffer size. Note that if the values are too
large, it will place a heavy load on the system. When determining these
values, be sure to consider these operational tradeoffs.
Table 3-6 Default and Recommended Values for the Integrated Trace File
Settings on page 3-13
integrated trace file settings.
Table 3-6 Default and Recommended Values for the Integrated Trace File
Integrated trace file size
Number of integrated trace files
Buffer size per
monitoring
interval
Number of
messages to be
output per
shows the default and recommended values for the
Setting
Monitoring cycle
Buffer size per
monitoring interval
Monitoring cycle
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for VMware(R))
: on(6)
: all
hh:mm:ss
Settings
Default value
256 (KB)
4
10 (seconds)
64 (KB)
0 (seconds)
#
Recommended
value
4096 (KB)
8
5 (seconds)
256 (KB)
0 (seconds)
3-13