Requirements For Outputting Audit Log Data - Hitachi XP P9500 User Manual

#1
The severity levels are as follows:
4: Warning, 6: Information
#2
If you use Ctrl + C to cancel the DLMgetras utility for collecting HDLM
error information, audit log data indicating that the DLMgetras utility has
terminated will not be output.

Requirements for Outputting Audit Log Data

HDLM can output audit log data when all of the following conditions are
satisfied:
• The Event Log service is running on the remote management client.
• The output of audit log data has been enabled by using the HDLM
command's set operation.
However, audit log data might still be output regardless of the above
conditions if, for example, an HDLM utility is executed from external media.
#:
The following audit log data is output:
¢
¢
2-26
Category Explanation
Categories: StartStop, Authentication, and ConfigurationAccess
Severity: 6 (Error, Warning, or Information)
HDLM Functions
Hitachi Dynamic Link Manager User Guide (for VMware(R))
Severity
Audit event
Setup of the
operating
environment
failed.
An attempt to
display program
information was
successful.
An attempt to
display program
information failed.
An attempt to
display HDLM
management-
target information
was successful.
An attempt to
display HDLM
management-
target information
failed.
Message ID
#1
4 KAPL15106-W
6 KAPL15107-I
4 KAPL15108-W
6 KAPL15109-I
4 KAPL15110-W
#