Hitachi XP P9500 User Manual page 125

29 Shut down the host.
.
30 Perform steps 21 to 29 on all the hosts that make up the cluster system.
.
31 Restart each host.
.
32 Install MSCS on each host.
.
33 Shut down all the hosts.
.
34 Restart each host again.
.
35 Log on to Windows as a member of the Administrators group.
.
36 Execute the dlnkmgr command's view operation to display the status of
.
each program.
Make sure that on MSCS is displayed in Support Cluster. An example of
executing the dlnkmgr command's view operation is as follows:
>dlnkmgr view -sys
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size (KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Remove LU
Intermittent Error Monitor
HDLM Manager Ver
Alive x.x.x-xx
HDLM Alert Driver Ver
Alive x.x.x-xx
HDLM Driver Ver
Alive x.x.x-xx
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
Installing HDLM after an MSCS Installation:
To install MSCS and then HDLM:
1 Install MSCS on the host.
.
2 Restart the host.
.
3 Log on to Windows as a member of the Administrators group.
.
4 Save the license key file directly under the Windows installation-
.
destination drive. Also, instead of using the license key file, you can
directly specify a license key during the installation of HDLM.
installation-drive:\hdlm_license
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
: x.x.x-xx
:
: on(extended lio)
: on MSCS
: 3
: 9900
: 2
: 0
: 1000
: 4
: on(30)
: on(1)
: off
: off
WakeupTime
yyyy/mm/dd hh:mm:ss
WakeupTime
yyyy/mm/dd hh:mm:ss 128
WakeupTime
yyyy/mm/dd hh:mm:ss
ElogMem Size
3-59