Hitachi XP P9500 User Manual page 91

Identify the physical volume that contains the boot logical volume
¢
hd5:
# lsvg -M rootvg | grep -w hd5
hdisk3:1
In this example, hdisk3 contains the boot logical volume hd5.
Identify the physical volume used for booting:
¢
# getconf BOOT_DEVICE
hdisk3
In this example, hdisk3 is used for booting.
If the boot physical volume that contains the logical volume hd5 is
different from the physical volume used for booting, the following
message appears, and the HDLM installation ends with an error:
0503-497 installp: An error occurred during bosboot test
processing.
To make the physical volume that contains the boot logical volume hd5
the same as the physical volume used for booting, execute the bootlist
command by specifying the physical volume that contains the boot logical
volume hd5, and then restart the host.
The following shows an example of executing the command when the
physical volume that contains the boot logical volume hd5 is hdisk3:
# bootlist -m normal hdisk3
After restarting the host, perform the procedure again from step 2.
4 If there is no directory for mounting the DVD-ROM, make the directory.
.
# mkdir /cdrom
cdrom is the desired directory name. Hereafter, cdrom is used for
purposes of explanation.
5 Mount the DVD-ROM.
.
# mount -r -v cdrfs /dev/cd0 /cdrom
The /dev/cd0 part depends on the system.
6 Execute the following command to check that the devices to be managed
.
by HDLM have been recognized by the system:
# lsdev -Cc disk
hdisk0 Available 1S-08-00-8,0
hdisk1 Available 1S-08-00-9,0
hdisk2 Available 1S-08-00-10,0 16 Bit LVD SCSI Disk Drive
hdisk3 Available 1H-08-02
hdisk4 Available 1H-08-02
...
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for AIX(R))
hd5:1
16 Bit LVD SCSI Disk Drive
16 Bit LVD SCSI Disk Drive
Hitachi Disk Array (Fibre)
Hitachi Disk Array (Fibre)
3-29