3.18 Setting Up HDLM
HDLM includes functions like the load balancing function, the automatic failback
function, the error logging function, the audit logging function, etc. You can set up
these functions by using the
3.18.1 Checking the Current Settings
Check the current settings by executing the following command to set the HDLM
functionality by using the
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size(KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Reservation Status
Intermittent Error Monitor
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
To check the current audit log settings, execute the following command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log
Audit Log Category
Audit Log Facility
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time =
#
3.18.2 Setting Up the HDLM Functions
The recommended and default values for each HDLM function is shown below in
Table 3-57: The Recommended and Default Values of Each Function.
command's
dlnkmgr
command's
dlnkmgr
view
x.x.x-xx
:
:
: on(extended lio)
:
: 3
: 9900
: 2
: 0
: 1000
: 4
: on(30)
: on(1)
:
: off
: off
: -
: -
yyyy
mm
dd
/
/
3. Creating an HDLM Environment
operation.
set
operation.
hh
mm
ss
:
:
271