Hitachi XP P9500 User Manual page 244

3. Creating an HDLM Environment
initrd-2.6.16.46-0.14-default.hdlm was created.
KAPL12330-I The utility for supporting the boot disk
completed.
24. When you create a new initial RAM disk image file rather than overwriting the
existing one, delete the existing initial RAM disk image file that is no longer
required.
Execute the following command:
• Execution example of the command when GRUB as the boot loader is used
# rm /boot/initrd-hdlm-2.6.9-11.EL.gz
• Execution example of the command when IPF (with ELILO as the boot
loader) is used
# rm /boot/efi/efi/redhat/initrd-hdlm-2.6.9-11.EL.gz
25. Edit the
/etc/fstab
Change the
to the HDLM device. Comment out the existing SCSI device specification by
placing a hash mark (
device specification as shown below, based on the correspondence between the
HDLM device and the SCSI device as checked in step 21.
#/dev/sda1
/dev/sddlmaa1
This example assumes that IA32 uses
that uses
instead of
displayed as
26. Edit the boot loader configuration file so that the OS will start with HDLM
specified.
Edit the boot loader configuration file as shown in Figure 3-20: Example of
Editing /etc/grub.conf file, Figure 3-21: Example of Editing /boot/grub/menu.lst
file (When using a kernel that supports Xen), and Figure 3-22: Example of
Editing /etc/elilo.conf file.
If you are using SUSE LINUX Enterprise Server 10 or SUSE LINUX Enterprise
220
file.
mount point that you changed in step 4 from the SCSI device
/boot
) at the beginning of each line, and then add the HDLM
#
as the boot loader, the mount point is displayed as
ELILO
in the line where
/boot
instead of
vfat ext3
:
:
/boot ext3 defaults
/boot ext3 defaults
:
:
as the boot loader. When you use IPF
GRUB
is coded, and the file system type is
/boot
.
1 2
1 2
/boot/efi