Hitachi XP P9500 User Manual page 197

1. Check the installation directory of the OS specified in the
# cat /etc/fstab
LABEL=/ /
LABEL=/boot
Confirm that LABEL indicates the root directory and the
2. Check the correspondence between the
# mount
/dev/sda2 on / type ext3 (rw)
none on /proc type proc (rw)
none on /dev/pts type devpts (rw,gid=5,mode=620)
usbdevfs on /proc/bus/usb type usbdevfs (rw)
/dev/sda1 on /boot type ext3 (rw)
none on /dev/shm type tmpfs (rw)
Confirm that the root directory is
.
dev/sda1
3. Using an editor such as vi, change the
specification.
(before)
LABEL=/ /
LABEL=/boot
(after)
/dev/sda2 /
/dev/sda1 /boot
4. Install HDLM.
5. After configuring the HDLM device, execute the
to exclude the HDLM device that corresponds to the boot disk as a
management target.
If the SCSI device name has been changed by using the
3.7.3 Settings for Using an HDLM Device as a Boot Disk and 3.7.4 Upgrade
Installation in an Environment Where an HDLM Device Is Used as a Boot Disk
and perform operations while reading the SCSI device names in those subsections
as the new SCSI device names (
function.
ext3 defaults
/boot ext3
LABEL
/dev/sda2
LABEL
ext3 defaults
/boot ext3
ext3 defaults
ext3 defaults
name) that were changed by using the
udev
3. Creating an HDLM Environment
setting.
LABEL
1 1
defaults 1 2
directory.
/boot
setting and the sd device.
, and the / directory is
boot
specification to an sd device
1 1
defaults 1 2
1 1
1 2
command
dlmcfgmgr -o
function, see
udev
/
udev
173