Removing Devices from VxVM
VxVM uses HDLM devices to access LUs managed by HDLM. Therefore, you
must remove non-HDLM devices (such as sd or ssd devices), which
correspond to the LU, from VxVM management.
In this section, excluding devices from VxVM management is called removing
devices.
The following describes devices that must be removed from VxVM, and the
procedure for removing such devices.
Devices to Be Removed from VxVM
Figure 3-22 Devices That Are Recognized by VxVM before They Are Removed
from VxVM on page 3-140
they are removed from VxVM.
Figure 3-22 Devices That Are Recognized by VxVM before They Are
You must remove the following non-HDLM devices that are recognized by
VxVM. If the following devices are being managed by VxVM, HDLM functions,
such as load balancing and failover, will not work normally.
3-140
shows devices that are recognized by VxVM before
Removed from VxVM
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))