Quick Guide
•
Charging the battery
/O
Charging
lamp
[CHARGE]
O
02
Lights
up:
Charging
_._
Goes off:
Charging
completed
O
Connect
the AC cable to the AC adaptor
and the AC outlet.
I_
Insert the battery
into the AC adaptor
by
aligning
the arrows.
•
Inserting the battery
Install the battery
by inserting
it in the
direction
shown
in the figure.
1)
Open the LCD monitor.
• Check that the access
lamp has gone off.
2)
Open the SD card/terminal
cover and
insert
(remove)
the SD card into (from)
the card slot.
• Face the label side Q in the direction
shown
in the illustration
and press it
straight
in as far as it will go.
• Press the center
of the SD card and then
pull it straight
out.
3)
Securely
close the SD card/terminal
cover.
• Securely
close it until it clicks.
•
Turning the unit on/off
Turning
the unit on and off with the
power
button
Press the power button
to turn on the unit.
®/I
O
Insert the battery
until it clicks and locks.
•
Inserting/removing
an SD card
O
The status indicator
lights on.
• To turn off the unit, hold down the power
button
until the status indicator
goes off.
Turning
the unit
on and off with the LCD
monitor/viewfinder
Opening
the LCD monitor
or extending
the
viewfinder
turns on the unit. Closing the LCD
monitor/viewfinder
turns off the unit.
To turn
on the unit
Access
lam p [ACCESS]
_
• When
this un t s accessing
the SD
card, the access
lamp lights up.
O
The status indicator lights on.
12
VQT3B18