Craftsman 950156 Operator's Manual page 11

Floor jack 4 ton capacity
Table of Contents

Advertisement

• Study,
understand,
and
follow
all
instructions
with
and on this device
before operating
this device.
• Do not exceed
rated capacity.
• Use only on hard, level surface.
• This is a lifting device only. Immediately
after
lifting,
support
the vehicle
with
appropriately
rated vehicle stands.
• Do not move or dolly the vehicle while
on the jack.
• Failure
to heed
product
markings
or
warnings
may result in personal
injury
or property damage.
Leer, comprender,
y seguir las instrucciones
antes de utilizar el aparato.
El
manual
de instrucciones
y la informacion
de
seguridad
deben
estar
comunicado
en
lengua
del operador
antes
del uso. No
seguir
estas indicaciones
puede
causar
danos personales
o materiales.
To avoid
crushing
and
related
injuries:
NEVER
work
on,
under or around
a load [
supported
only by jack.
ALWAYS use adequately
rated jack stands.
! SAFETY
MESSAGE
!
Be sure all tools and personnel
are clear
before
lowering
load.
No alterations
shall
be made
to this
product.
Only
attachments
and/or adapters
supplied
by
the manufacturer
shall be used.
Lift only
on areas of the vehicle as specified
by the
vehicle manufacturer.
NOTE:
Jack
stands
are rated
per pair
unless otherwise
noted.
Use 1 matched _
per vehicle only.
A
T _,
v
TO ASSEMBLE THE TWO PIECE
HANDLE
• Locate the spring pin on bottom end of upper
handle and the spring pin receiver on the
upper end of lower handle. (Fig. 1).
• Align
the spring
pin with the spring
pin
receiver.
Connect
the two handle
pieces
together
by pressing
the spring
pin and
insert until the spring
pin is locked in the
spring pin receiver.
TO ASSEMBLE THE HANDLE INTO
THE SOCKET
1. Press and hold the handle socket to loosen
the lock pin (Fig. 2).
2. Pull out the lock pin, then release
handle
socket slowly.
,_l_Caution:
Handle socket is spring loaded.
Beware
of pinching
on fingers
during
removal of lock pin.
3. Pull and hold the spring knob (Fig. 3).
4. Insert
the assembled
handle
into
the
socket,
until it is firmly seated.
5. Release spring knob to secure the handle
in position.
S/p,ri n g Pin
/
/Spring
Pin Receiver
Upper Handle
Lower Han_dll
FIG.
1
FIG. 2
Handle Socket_
o
/ ®
hold the
"_"_'_.,_
position of Handle
tL.(_]
Socket in packaging)
Assembled
_._,
Handle Socket
Handle
---_
/_
Spring Knob ---______
FIG.
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Speedy lift 50156

Table of Contents