Hoover FloorMate SpinScrub Hard Floor Cleane Owner's Manual page 13

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
A WARNING A
To reduce risk of personal injury - unplug cleaner before servicing.
PROBLEM
Cleaner won't
run
Low suction
Water puddling
behind cleaner
Won't pick up
dirty solution
Cleaner solution
won't dispense
Brushes won't
rotate
POSSIBLECAUSE
2. Blown fuse or tripped breaker.
2. Dirty Water Tank full and the
automatic shut-off engaged.
4. Filter or Filter lid not in place.
POSSIBLESOLUTION
2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
2. Empty the Dirty Water Tank.
4. Make sure Filter and Filter lid are properly
positioned.
1. Wrong detergent used. 1. Use recommended detergents to reduce
foaming.
3. Dirty water tank full. 3. Empty dirty water tank.
2. Dirty water tank full. 2. Empty Dirty Water Tank,
1. Tanks not in place. 1. Make sure tanks are locked in place.
1. Blown fuse or tripped breaker. 1. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
(1) Push ON/OFF switch to turn cleaner OFR
(2) Unplug the cleaner.
(3) Wait one minute.
(4) Plug the cleaner into electrical outlet.
(5) Push the ON/OFF switch again to turn
cleaner ON.
If the brushes continue to stall and the breaker
trips again, clean the brushes to remove debris.
13