Download  Print this page

Kenmore 625.385560 UltraFilter 650 Owner's Manual page 22

Reverse osmosis system
Hide thumbs

Advertisement

Supply
water
pressure limits ................................................
40-100
psi (280-689
kPa)
Supply
water
temperature
limits ...............................................
40-100
°F [4.5-37.7°C}
Maximum
total dissolved
solids (TDS} ....................................................
2000
ppm
Maximum
water
hardness @ 6.9 pH ........................................................
10 gpg
Maximum
iron, manganese,
hydrogen
sulfide
......................................................
0
Chlorine
in water
supply
(max. ppm)
..........................................................
2.0
Supply
water
pH limits (pH) .................................................................
4-10
Product
(quality)
water, 24 hours '
...............................................
18.4 gal. (69.6 liters)
Percent rejection
of TDS, minimum
(new membrane)
_ .............................................
86.5
Automatic
shutoff
control
....................................................................
yes
Efficiency
_ ............................................................................
12.2 %
Recovery 3 .............................................................................
22.9 %
This system conforms
to NSF/ANSI
42 and 58 for the specific
performance
claims as verified
and substantiated
by
test data.
_@ Feed water
supply at 50 psi, 77°F, and 750 TDS. Quality
water
production,
amount
of waste water
and percent
rejection
all vary with changes
in pressure, temperature
and total dissolved
solids.
_Efficiency
rating means the percentage
of the influent
water
to the system that is available
to the user as reverse
osmosis treated
water
under operating
conditions
that approximate
typical
daily
usage.
3Recovery rating
means the percentage
of the influent water
to the membrane
portion
of the system that is available
to the user as reverse osmosis treated
water
when the system is operated
without
a storage tank or when the storage
tank is bypassed.
Non-potable
Water Sources: Do not attempt
to use this product
to make safe drinking
water
from non-potable
water
sources. Do not use the system on microbiologically
unsafe water, or water
of unknown
quality
without
an adequate
disinfection
before or after
the system. This system is certified
for cyst reduction
and may be used on disinfected
water
that may contain
filterable
cysts.
Arsenic Reduction:
This system shall only be used for arsenic reduction
on chlorinated
water
supplies
containing
detectable
residual
free chlorine
at the system inlet. Water
systems using an inline chlorinator
should provide
a one
minute chlorine
contact
time before
the reverse osmosis system.
Nitrate/Nitrite
Test Kit: This system is acceptable
for treatment
of influent
concentrations
of no more than 27mg/L
nitrate
and 3mg/L
nitrite
in combination
measured
as N. It is certified
for nitrate/nitrite
reduction
only for water
sup-
plies with a pressure of 280 kPa (40 psig) or greater.
This system is supplied
with a nitrate/nitrite
test kit. Product
water
should be monitored
periodically
according
to the instructions
provided
with the test kit.
TDS Test Kits: TDS test kits are available
by calling
1-800-949-8220,
or check the water
testing section
of your local
phone directory.
Installations
In The Commonwealth
Of Massachusetts:
The Commonwealth
of Massachusetts
requires installation
be
performed
by a licensed
plumber
and do not permit
the use of saddle
valves. Plumbing
code 248-CMR
of the
Commonwealth
of Massachusetts
must be followed
in these cases.
Product Water Testing: The Reverse Osmosis System contains
a replaceable
treatment
component
critical
for the effec-
tive reduction
of total dissolved
solids. Product water
should be tested periodically
to verify
that the system is perform-
ing properly.
Replacement
of the reverse osmosis component:
This reverse osmosis system contains
a replaceable
component
criti-
cal to the efficiency
of the system. Replacement
of the reverse osmosis component
should
be with one of identical
specifications,
as defined
by the manufacturer,
to assure the same efficiency
and contaminant
performance.
Questions?
Call The Kenmore
Water
Line 1-800-426-9345
or visit KenmoreWater.com
22

Advertisement

loading

  Also See for Kenmore 625.385560 UltraFilter 650

  Related Manuals for Kenmore 625.385560 UltraFilter 650

This manual is also suitable for:

Elite 625.385560Elite ultrafilter 650