Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle; Option Selections - Kenmore ULTRA WASH 665.13485 Use & Care Manual

QuickRinse
Use this rinse cycle for rinsing dishes, glasses, and
silverware that will not be washed right away.
Do not use detergent with this cycle.
Wash Main Rinse Final Dry Time Water
Wash or Rinse (rain) Usage
Purge (gal/L)
• 10 1.8-2.2/
Rinse 6.8-8.3
-A small amount of water is run through the pump to
remove soil particles between the main wash and final
rinse.
*If the incoming water temperature is less than the
recommended temperature or food soils are heavy, the
cycle will automatically compensate by adding time,
heat, and water as needed.
**Hard water is defined as 7 grains per U.S. gallon and
above.
NOTE: The sensor in your dishwasher monitors the soil
level. Cycle time and/or water usage can vary from the
numbers above as the sensor adjusts the cycle for the
best wash performance.
.
2.
Press CANCEL/DRAIN. The Cancel/Drain light glows.
The dishwasher starts a 2-minute drain (if needed). Let
the dishwasher drain completely. The light turns off
after 2 minutes. The door must be closed for the
dishwasher to drain.
To stop the drain
You can press CANCEL/DRAIN again to stop the drain. Be
sure to drain the dishwasher before starting a new cycle.
To clear the indicators
Press CANCEL/DRAIN before starting the dishwasher to
clear all options and cycles.
During the first minute of a cycle
1. Select a new cycle and/or options.
2. Check the detergent dispensers. They must be filled
properly for the new cycle.
3. The Start/Resume light will flash when the door is
opened. Make sure the door is closed.
4. Press START/RESUME.
After the first minute of a cycle
1. Press CANCEL!DRAIN. The Cancel/Drain light glows.
Your dishwasher starts a 2-minute drain (if needed). Let
the dishwasher drain completely.
2. Check the detergent dispensers. They must be filled
properly for the new cycle.
3. Make sure the door is closed. The Start/Resume light
will flash.
4. Select a new cycle and/or options.
5. Press START/RESUME.
You can add an item anytime before the main wash starts.
Open the door and check the detergent dispenser. If the
cover is still closed, you can add items.
To add items
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door. The
Start/Resume light will flash.
2. Open the door. If the detergent dispenser cover is still
closed, add the item.
3. Close the door firmly until it latches. The Start/Resume
light will flash.
4. Press START/RESUME.
IMPORTANT: If Lock On is selected, turn off the lock (see
Lock On section in "Option Selections"), or the Start/
Resume light will continue to flash.
O on ect
You can customize your cycles by pressing an option. If
you change your mind, press the option again to turn the
option off, or select a different option if desired.
You can change an option anytime before the selected
option begins. For example, you can press an unheated
drying option anytime before drying begins.
Press START/RESUME to use the same cycle and
option(s) as the previous wash cycle.
NOTE: If the last cycle you completed was a rinse cycle,
when you press START/RESUME, the dishwasher runs the
last full wash cycle and options.
16