Sharp FO-P610 Operation Manual page 80

Messages and Signals
LINE ERROR
MEMORY IS FULL/
SEE MANUAL
(alternating messages)
MEMORY PRINTING
NEAR END OF FILM/
REPLACE FILM
NO DATA
OFF HOOK
ON HOOK DIAL
OVER HEAT
PRINT HEAD FAIL/
YOU NEED SERVICE
(alternating messages)
READY TO SEND
78
Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error on page 72.
The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been received
to memory because printing is not possible (an
additional message will indicate the problem), resolve
the problem so that printing can continue (see
Substitute Reception to Memory on page 49). If you
are attempting to transmit from memory, see If the
memory becomes full on page 40. If you are copying,
see If MEMORY IS FULL appears on page 50.
The fax is preparing to or printing out a document
from memory.
This message appears 3 m from the end of the
imaging film (approximately 10 pages can still be
printed), and alerts you that you will soon need to
replace the film.
This appears if you attempt to search for an auto-dial
number when none have been stored.
This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.
The SPEAKER key has been pressed and the fax
machine is waiting for you to dial.
The print head has overheated. Operation can be
continued after it cools. If overheating frequently
occurs, try changing the print contrast setting to
LIGHT (see page 18).
The print head has failed and requires service.
A document has been loaded and the fax machine is
waiting for you to begin faxing or copying.