Replace Tv Station Positions; Manual Tv Station Presetting - Sharp DV-RW250X Operation Manual

Setting the channel

Replace TV station positions

You can replace the channel positions as you like.
Example: Replace the TV station No. 6 with position
No. 2.
1
Select "CH TUNING" and press ENTER.
2
Select "CH" and press ENTER. Then select the
moving channel position number (6) and press EN-
TER.
CH 6
SKIP OFF
MOVE 6
3
Select "MOVE" and press ENTER.
CH 6
SKIP OFF
MOVE 6
4
Select the channel position number (2) to which
the selected position at step 2 above is to be moved
and press ENTER. Now these channel positions
were replaced with each other.

Manual TV station presetting

The Automatic station presetting function (See page
26) memorises the available broadcasts to suitable CH
positions.
Some broadcasts may not be preset correctly by the
automatic tuning system - in this case you can tune
stations manually as follows.
Example: Presetting a station on program position 5.
1
Select "CH TUNING" and press ENTER.
2
Select "CH" and press ENTER. Then select the
channel position number (5) and press ENTER.
CH 5
SKIP OFF
MOVE 5
3
Select "TUNING" (tuning scale) and press ENTER.
CH 5
SKIP OFF
MOVE 5
TUNING
4
Press A (rising frequency) or B (falling frequency)
once. The search starts. It stops at each broadcast
automatically. ("A" changes to "
repeatedly until the desired station appears. If the
broadcast is too weak (eg. with a drifting picture),
the search will not stop. If you want to stop, press
C/D or B/A.
CH 5
SKIP OFF
MOVE 5
TUNING
SEARCH F. TUNE
ENTER ENTER RETURN BACK
5
If the tuned-up picture is not satisfactory, press C
or D until the best picture is achieved. Then press
ENTER.
6
Repeat the steps 2 and 5 to preset other TV sta-
tions.
NOTE:
Occasionally, the auto search might catch a weak sig-
nal and stop. If the TV station signal is weak, you
shouldn't store this station. In that case restart the auto
search using B or A.
") Press B or A
SETUP END
27