Interrupting A Copy Run - Sharp AR-M256 Operation Manual

INTERRUPTING A COPY RUN

A copy run can be temporarily interrupted to allow another copy job to be performed. When the other job is finished,
the copy run will resume using the original copy settings.
Automatic two-sided copying, sort/group copying, staple sort, pamphlet copy, mix feeding, job build, cover copy,
Note
job programs, card shot, card shot, or multi shot copying cannot be used for interrupt copying.
1
Press the [INTERRUPT] key (
interrupt the copy run.
• If audit mode is enabled, a message will
Note
appear prompting you to enter your
account number. Enter your account
number with the numeric keys. The copies
that you make will be added to your
account's count.
• If an original is being scanned when the
[INTERRUPT] key (
interrupt job will begin after the original is
scanned. If a copy is being printed, the
interrupt job will begin after the copy is
printed.
2
Remove the previous original(s) and
place the original(s) of the interrupt
copy job. (p.22, p.23)
3
Select the number of copies and any
other desired copy settings, and then
press the [START] key (
ACC.#-C
34
) to
The [INTERRUPT] key
( ) blinks until the
machine is ready for the
interrupt job, after which
it lights steadily.
If you decide to cancel
the interrupt job while
selecting settings, press
the [INTERRUPT] key
( ).
) is pressed, the
).
The interrupt copies will
be offset from the
previous copies. (Offset
function, p.35)
4
When the copy job is finished, press
the [INTERRUPT] key (
the original(s).
5
Replace the previous original(s) and
press the [START] key (
copying.
Replace only the originals that have not yet been
scanned.
) and remove
) to resume