Sharp AR-F151 Facsimile Operation Manual page 30

Fax Setup
10
11
Step 4 or
Note: You may need to add a pause between certain digits in the number to allow time
for connection. For example, if you are on a PBX telephone system that requires
an access number, such as "9", to be dialed to access an outside line, you will
need to enter a pause between the access number and the fax number of the
other party. Pauses are entered by pressing the REDIAL/PAUSE key (2 seconds
per pause). If necessary, several pauses can be entered in a row.
Use the following procedure to clear numbers:
Step Press these keys
1
FUNCTION
2
3 ABC
4
01
5
ENTER
6
Step 4 or
2-20
ABC
or
STOP
STOP
. . .
DEF
(example)
STOP STOP
. . .
INITIAL SETTINGS
Press "1" if you want to specify the
number as a Chain Dialling number
(see "Chain Dialling for Long Numbers"
in this section).
Otherwise, press "2".
Return to Step 4 to store another
number, or press the STOP key a
number of times until you exit. If the
number is a Rapid key number, you
can write the name on the label above
the appropriate Rapid key.
Comments
"ENTRY MODE" will appear in the
display.
"FAX NUMBER MODE" will appear in
the display.
Select CLEAR. "FAX NUMBER
CLEAR" will appear in the display.
To clear a Rapid key number, press
the appropriate Rapid key. To clear a
Speed Dial number, enter the 2-digit
number with the number keys.
"PRESS ENTER KEY" will appear in
the display. If there is no number
stored under that Rapid key or Speed
Dial number, "NO NUMBER
STORED" will appear in the display.
"CLEARED" will appear in the display.
Return to Step 4 to clear another
number, or press the STOP key a
number of times until you exit.