Back; Included - Sharp FU-S40E Operation Manual

POWER ON/OFF Button

BACK

Air Outlet
Handle
Rating Label
Air Inlet
Power Cord
Power Plug
(Sharp of plug depends on country.)
Plasmacluster Indicator Light
(Please refer page E-9)
Blue light
When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmaclus-
ter Ion Mode and the air in the room is impure, the light will be activated and the
unit will operate in Clean Mode.
Green light
When the Plasmacluster ion operation is in the Ion Control Mode, or in AUTO
Plasmacluster Ion Mode and the air in the room is clean, the light will be activated
and the unit will operate in Ion Control Mode.
Cycles of blue and green
When the Plasmacluster ion operation is in the ION SHOWER Mode, Plasmacluster
Indicator Light lights will repeat its colour cycles between blue ang green.
CLEAN - SIGN Light
The colour changes according to
the air condition.
ABOUT THE CLEAN-SIGN
• The condition of the CLEAN-SIGN depends on the room air condition detected
by the Odour Sensor when the plug is inserted into the wall outlet.
• It is possible to have a green CLEAN-SIGN with impurities in the air at the time
that the air purifier was just introduced to the room environment. After a while,
however, the base impurity rate will be adjusted to detect room air condition
correctly.
DETERMINING THE BASE IMPURITY RATE
For the first 30 seconds after the power plug is inserted into the wall outlet, the
unit will check the conditions of the air. If operation is set to ON during this time,
the CLEAN-SIGN Light will alternately flash in green, yellow and red.
E-5
Clean Slightly Impure
Green Yellow

INCLUDED

• Operation manual
Very Impure
Red