Sharp FU-S40E Operation Manual page 11

*Ion Control Mode
Negative ions will
be released in an
increased rate and
controls the ion
balance.
Plasmacluster Indicator Light
CLEAN - SIGN Light
POWER ON/OFF Button
ION SHOWER Mode Button
ION SHOWER Mode Button
When pushing the ION SHOWER Mode button, the ION SHOWER
operation will be activated. (Direct start is available even when the unit is
not turned on.)
The concentrated Plasmacluster Ions (ION SHOWER) will be generated
in the room like a shower for 15 minutes, repeating the airflow cycles
between strong and gentle. (The Plasmacluster Indicator Light repeats its
colour cycles between blue and green.), and effectively controls the airborne
dust, pollen, mold, and allergen.
•When finished the operation, the unit will retuen to the prior operation.
•When pushing the ION SHOWER button while the ION SHOWER
operation mode is working, the unit will return to the prior operation.
Plasmacluster Ion Mode Selection Button
The Plasmacluster Ion mode can be switched.
AUTO
The unit will switch between Clean Mode and the Ion Control Mode*
automatically depending on the amount of impurities in the air as
detected by the odour sensor. Clean Mode will operate for 10 minutes
when the Auto function is selected.
CLEAN
The unit will constantly operate in the Clean Mode, in which the same
numbers of positive and negative ions are discharged. The
Plasmacluster Indicator Light is blue.
ION OFF
The generation of ions will stop and the Plasmacluster Indicator Light
will go out.
LIGHTS ON/OFF Button
(Please press the Plasmacluster Ion Mode Selection Button for 3 seconds.)
Switches the Plasmacluster Indicator Light and CLEAN-SIGN Light ei-
ther ON or OFF.
E-9