Using Emp Monitor - Epson PowerLite 830p User Manual

■ To change the network addresses from the projector's control
panel, press the right and left arrow buttons to select the part
of the address you want to enter, then use the up and down
arrow buttons to increase or decrease the numeric value.
Select the part of the
address to change
When you finish changing an address in the network menu, press
the button (on the remote control) or the
Enter
button (on the projector).
5. When you're done, press

Using EMP Monitor

EMP Monitor lets you use a remote computer to manage your
projectors over a wired network. It lets you easily turn the projectors
on or off (together or individually), switch image sources, and check
their status.
Before using EMP Monitor, make sure you've installed the software
(available for Windows only) as described on page 114. The
computer you're using to monitor the projector should already
be connected to your network.
Increase
or
decrease
the value
to exit the menu system.
Esc
Auto/Enter
note
If you want to monitor
projectors while they are in
standby mode, select
Standby Mode
Extended menu, then select
Network ON
Managing Projectors
in the
. See page 75.
81