Preparation; Inserting Batteries In The Remote Control; Remote Control Use - Sharp FU-60SE-P Operation Manual

PREPARATION

INSERTING BATTERIES IN THE REMOTE CONTROL

• The batteries for this remote control are for initial use only . Change the
• Incorrect usage of the batteries may cause battery fluid leakage and/or
• When replacing the batteries, replace both batteries with new ones of the
• When not using the unit or remote control for an extended period, re-
• The batteries of the accessory are for initial use only and may be de-

REMOTE CONTROL USE

• Operate with the remote control facing the main
unit (Receiver).
• The signal range is about 7 m (front).
• Make sure there are no objects blocking the path
of the signal.
• A beep sound will be heard from the main unit
when a signal is received.
NOTE
• Avoid dropping or damaging the remote control. In addition, be sure the remote control
avoids moisture or place in direct sunlight or near an electric heater, etc., otherwise a
malfunction may occur.
batteries when necessary.
damage.
Take care of the following when handling:
same type. (Use R6(AA) manganese batteries (2 units).)
move the batteries. (This prevents malfunction of the remote control from
battery fluid leakage.)
pleted within 1 year.
1
Remove the back cover
Press and slide the back cover to re-
move.
2
Insert batteries
Insert batteries with
shown below.
3
Close the back cover
Battery Information
E-7
and
Receiver
Transmitter
as