Cleaning The Printer (Print Head / Sensor / Roller); Removing The Till And The Drawer; Opening The Drawer By Hand - Sharp XE-A202 Instruction Manual

A202_5 OPERATOR MAINTENANCE
7

Cleaning the Printer (Print Head / Sensor / Roller)

When the printed text is getting dark or faint, paper dust may be stuck to the print head, sensor and/or roller.
Clean them as follows:
Caution:
• Never touch the print head with a tool or anything hard as it may damage the head.
• The paper cutter is mounted on the printer cover. Be careful not to cut yourself.
Print head
Roller
8

Removing the Till and the Drawer

The till in the register is detachable. After closing your business for the day, remove the till from the drawer and
keep the drawer open. The 8-denomination coin case is also detachable from the till. To detach the drawer, pull
it forward fully with the till removed, and remove it by lifting it up.
9

Opening the Drawer by Hand

Lever
03.7.5 8:11 AM Page 67
1.
Turn the mode switch to the "
2.
Remove the printer cover.
3.
Lift up the print roller release lever to unlock and open the
print roller arm.
4.
Remove the paper roll referring to the "Removing the
paper roll" section.
5.
Clean the print head with a cotton swab or soft rag
moistened with ethyl alcohol or isopropyl alcohol. Clean
the print roller and the sensor in the same manner.
6.
Sensor Reset the paper roll correctly by following the steps in
"Installing the paper roll".
Till Coin case
Bill case
8-denomination coin case
(detatchable)
Drawer
The drawer automatically opens. However, when a power failure occurs or the
machine becomes out of order, slide the lever located on the bottom of the
machine in the direction of the arrow. (See the diagram at the left.)
The drawer will not open if it is locked with the key.
" position.
1
2
67