Direct Dubbing; Copying A Video Tape - Sharp DV-NC200X Operation Manual

When an OTR or a Timer Recording is completed...
•
If the other Timer Recordings remain as programmed, the VCR/DVD
switches to the DVD mode automatically, and the TIMER indicator on
the front panel lights up to indicate the VCR/DVD is in the timer standby
mode. In some occasions, however, the VCR/DVD may be automatically
turned off, instead of changing to the DVD mode after pressing
TIMER ON/OFF.
•
The TIMER indicator on the front panel flashes if there are no more Timer
Recordings on standby. If you want to use the VCR function, press
TIMER ON/OFF on the remote control or STOP C/EJECT A on the VCR/
DVD. Then press VCR to activate the VCR function.
•
Once the VCR/DVD switches to the DVD mode, all the VCR function will
be unavailable. " " will not appear as long as the DVD is in use. All the
DVD functions are available during OTR, timer standby mode and Timer
Recording.

Direct Dubbing

VCR DVD
press first.
1 2 3
4 5 6
7 8 9
0 +10
PLAY
STOP
VCR/DVD COMBINATION NA527AD
Refer to page 7 to switch between the VCR mode and the DVD mode.
This will be possible only if the DVD is not copy protected.
1. Insert a tape.
with erase-protection tab
2.
Insert a disc with label facing up.
3.
Press 0, 0, 3 to select DISC.
or
4. Select the desired tape speed.
SP

Copying a Video Tape

Warning: Unauthorised recordings of copyrighted video tapes may be an infringement of copyright laws.
Connect the recording VCR/DVD(this unit), playing VCR(another VCR) and your TV as outline in the following diagram.
(Back of another source)
or
1. Insert a pre-recorded tape into the playing VCR.
2. Insert a tape with its erase-protection tab into the recording
VCR/DVD.
3. Press TAPE SPEED on the remote control of the recording
VCR/DVD to select the desired recording speed (SP/LP).
4. Select the "AV1" or "AV2" position on the recording VCR/DVD.
• To use the input jacks on the back of this VCR/DVD, select "AV1"
position by pressing 0, 0, 1 on the remote control or CH K / L.
• To use the input jacks on the front of this VCR/DVD, select "AV2"
position by pressing 0, 0, 2 on the remote control or CH K / L.
5. Press REC on the recording VCR/DVD.
6. Begin playback of the tape in another source.
7. To stop recording, press STOP C/EJECT A on the VCR/DVD for
the recording VCR/DVD, then stop playback of the tape in another
source.
H9945AD_1.indd 18 H9945AD_1.indd 18
•
If necessary, rewind or fast
forward the tape to the point
at which you want to begin
recording.
TV Screen
Tape Type Recording / Playback Time
Tape Speed SP Mode LP Mode
E-60 1 hour 2 hours
E-120 2 hours 4 hours
E-180 3 hours 6 hours
E-240 4 hours 8 hours
AUDIO OUT
1
L
DV D /V C R V C R
C O M P O N E N T
AU D IO O U T AU D IO IN
V ID E O O U T
A N T -IN
Y L L
R
C
B R R
V ID E O O U T V ID E O IN
A N T -O U T
VIDEO OUT
C
R
Video/Audio cables
(supplied)
*Front input jacks are also available.
• When you use the VCR/DVD in DVD mode during an OTR or a Timer
Recording, the VCR/DVD will not turn off automatically even if the end
time of the OTR or Timer Recording has been past.
Note (for Timer Recording) :
•
If there is a power failure or the VCR/DVD is unplugged for more than 1
hour, clock and all timer settings will be lost.
To avoid overlap of Timer Programming ...
• A timer programme will not work while another programme is under
execution.
Programme 1
Programme 2
Programme 3
9:00
5.
Recording starts.
6.
7.
To Stop Recording.
DISC
Hint
• Press STILL/PAUSE F at the point where you want to start record-
ing when you do dubbing middle of the DVD.
• To stop recording temporarily, press STILL/PAUSE F after press
VCR. Press STILL/PAUSE F again to resume recording.
• You cannot record properly from the DVD disc recorded in the
NTSC system.
(Back of Recording VCR/DVD*)
DV D /V C R V C R
N T
AUDIO OUT AUDIO IN AERIAL
T
L L
R R
RF OUT
VIDEO OUT VIDEO IN
Round Coaxial cable
(supplied)
Hint
• For best results during dubbing, use the front panel controls when-
ever possible. The remote control might affect another source's
operation.
• If video or colour fades in and out, you may be copying a copy
guarded video tape.
• Unauthorised recording of copyrighted materials may infringe on
the rights of copyright owners, violate copyright laws and may not
record clearly.
• "AV1" or "AV2" is found before the lowest memorised channel.
(Example: P02)
• "AV2" input jacks are on the front of this VCR/DVD.
– 18 –
10:00 11:00
Playback starts.
To Stop Playback.
(Back of TV)
2
EN
5/11/2005 6:47:36 PM 5/11/2005 6:47:36 PM