Timer Operation - Sharp AY-XP08CE Operation Manual

TIMER OPERATION

NOTE:
Before setting the timer, make sure the clock is properly set with the current time.
TIMER OFF
AM
DISPLAY
FULL
POWER
MODE
1h
FAN
SWING CLEAN
SET/C
TIPS ABOUT TIMER OFF OPERATION
When the TIMER OFF mode is set, the
temperature setting
adjusted to prevent the room from
becoming excessively hot or too cold
while you sleep. (Auto Sleep function)
COOL/DRY MODE:
• One hour after the time operation begins,
the temperature setting rises 1°C higher
than the original thermostat setting.
HEAT MODE:
• One hour after the timer operation
begins, the temperature setting drops
3°C lower than the original thermostat
setting.
NOTE:
• The Auto Sleep function will not acti-
vate during the FAN ONLY mode.
1
Press the TIMER OFF (
2
The TIMER OFF indicator will blink; press the
TIME ADVANCE or REVERSE buttons to set
the desired time. (The time can be set in 10-
minute increments.)
3
Point the remote control at the signal receiver
window on the unit and press the TIMER SET
(SET/C) button.
• The orange TIMER lamp (
light.
• The unit will generate a beep when it re-
ceives the signal.
1
2
3
is automatically
E-14
TO CANCEL TIMER MODE
Press the TIMER CANCEL (SET/C) button.
• The orange TIMER lamp (
will turn off.
• The current clock
time will be dis-
played on the re-
mote control.
NOTE:
• If any TIMER ON, TIMER OFF and ONE-
HOUR OFF TIMER are set, the TIMER
CANCEL button cancels all settings.
TO CHANGE TIME SETTING
Cancel the TIMER seting first, then set it
again.
) button.
) on the unit will
) on the unit
MODE 1h
FAN
SWING CLEAN
SET/C