Inserting A Cassette; Inserting A Card - Sharp ViewCam VL-NZ100S Operation Manual

Inserting a Cassette

1
Attach the power source to the
camcorder, then slide the cassette
compartment door release and open the
cassette compartment door.
• After confirmation sound, the cassette
holder extends and opens automatically.
Cassette compartment
door release
2
Insert a commercially available cassette
fully with the window facing outwards,
and with the erasure protect tab facing
upwards.
Erasure protect tab
SAVE
C E R
3
Press the W mark gently until the
cassette holder clicks into place.
• After confirmation sound, the cassette
holder retracts automatically.
"W" mark
4
Wait for the cassette holder to fully
retract. Close the compartment door by
pressing the centre until it clicks into
place.

Inserting a Card

You can use an SD Memory Card or a
MultiMediaCard for storing still images.
1
Make sure that the Power switch is set
to OFF.
2
Slide the card slot cover release and
open the card slot cover in the direction
of the arrow.
Card slot cover release
3
Insert a card into the slot as shown
below, and push it in as far as it will go.
Write-protect
switch
Label
Clipped corner
4
Close the card slot cover.
Note:
• You cannot use a SmartMedia™ card or
Memory Stick™ media. In this operation
manual, "card" refers to the SD Memory Card
or the MultiMediaCard.
ii