Table of Contents
Advertisement
Basic Operations
Basic Operations
Camera Recording
Playback
Tape Playback
Available mode:
TAPE-VCR
The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be
connected, allowing instant on-screen play-
back with the sound through the built-in
speaker.
Media Selection switch
Operation button
1
Set the Media Selection
switch to TAPE.
2
Hold down the Lock button
and set the Power switch to
VCR.
3
Press j (or k) on the Operation button
to rewind (or fast forward) the tape to the
desired point.
4
Press m to begin playback.
Note:
• If you press the REC START/STOP button in
TAPE-VCR mode, the "
the camcorder enters Recording Standby mode.
If you do not intend to record, press l to turn
" mark off, then press m to begin
the "
playback. This will ensure your previous
recording is not erased (see pages 49, 51).
23
To stop playback
Press l.
To turn the power off
Set the Power switch to OFF without pressing
Power switch
the Lock button.
Note:
• The tape is automatically rewound when
playback reaches the end of the tape.
Using Earphones
(Commercially
Available)
Available modes:
TAPE-VCR, TAPE-CAMERA
You can monitor the sound via stereo ear-
phones (commercially available) during
playback or recording. Stereo earphones with a
3.5 mm diameter plug can be used with this
camcorder.
Connect the plug of stereo earphones to the
PHONES jack on the camcorder as shown
Lock button
below.
Notes:
• Before connecting stereo earphones, turn the
" mark appears and
camcorder volume down to the lowest setting.
• The built-in speaker automatically turns off when
stereo earphones are connected to the PHONES
jack.
PHONES jack
Advertisement
Table of Contents
