Recording From An External Source; To Stop Recording - Sharp Vl-H400X Operation Manual

TV with monitor output
Video disc player
STOP button
RECORDING FROM
AN EXTERNAL SOURCE
Yellow: To VIDEO termtnal
Red: To AUDIO (R) terminal
can record or edit on this
Y
OU
sources such as a VCR, TV, or video
Connect the VIEWCAM to the source equipment
with the supplied audio/video cable as shown to the
left.
If the source equipment has an S-video output terminal,
l
connect it to the VIEWCAM's S-VIDEO socket with the
supplied S-video cable.
To S-VIDEO
If the source equipment has only one audio output
l
terminal, connect the white
leave the red one unplugged.
While the S-video cable is plugged
l
S-VIDEO socket, the VIDEO terminal does not accept
recording signals. (Audio signals can be recorded.)
When you wish to record through the
be sure to leave the S-VIDEO socket unplugged.
TO RECORD FROM AN EXTERNAL
SOURCE
1
To S-VIDEO
output terminal
Yellow: To VIDEO OUT terminal
Red: To AUDIO OUT (R) terminal
terminal
To pause recording, press the PAUSE/STILL button on
l
the VIEWCAM. Press the PAUSE/STILL button again to
resume recording.
The AV terminal mode ("AV IN/OUT" on the menu
l
display) should normally be set to output ("OUT").

TO STOP RECORDING

Press the STOP button on the VIEWCAM.
plug to that terminal, and
into the VIEWCAM's
VIDEO terminal,
Set the OPERATE switch to VCR.
by
the menu display.
Start sending audio/video signals from the
source equipment connected
to the VIEWCAM.
Check on the VIEWCAM's monitor to see if the
picture properly received.
is
Press the REC button-on the VIEWCAM to start
recording.
IN
from other
disc player.
mode to