Sharp CR27FS1 Operation Manual page 30

Table of Contents

Advertisement

Available languages

Available languages

Operation of Remote Control (Continued)
L HOW TO IDENTIFY A VCR
The remote control may already be set to
operate your VCR. Try this initial check before
going on to the following "identify" section.
(1) Slide CATV/DVD-TV/VCR switch to VCR.
(2) Point remote towards VCR and press DVD/
VCR POWER .
(3) Does the remote turn the VCR ON and OFF?
• If yes, the remote is ready to operate the VCR
and no further steps are needed.
• If no, continue to the "identify" section.
L To Identify Your VCR – Direct Entry Method.
Use the following steps and list to quickly find
the remote control code for your accessory
VCR.
• First look up your VCR's remote control code
number before going through the direct code
entry steps control.
• If this procedure does not identify your
accessory VCR, use the Search method of
identification (described in the next section).
(1) Slide CATV/DVD-TV/VCR switch to VCR.
(2) Press and hold down DISPLAY and CH
DOWN ( 9 ) on your remote control.
Then release both buttons.
(3) Within ten seconds after releasing DISPLAY
and CH DOWN ( 9 ) , enter your VCR's two-
digit remote control code number using the
REMOTE KEYPAD (refer to list).
• The remote control is now ready to send
commands to your VCR.
30
29-31 CR27FS1[E].p65
POWER
TV
DVD
VCR
DISPLAY
TV
POWER
1
2
REMOTE
4
5
KEYPAD
7
8
FLASHBACK
0
PERSONAL PREFERENCE
A
B
C
CH
VOL
CH
MENU
CATV
DVD
REW
PLAY
FF
PAUSE
STOP
REC
Note:
L To Identify Your VCR – Search Method.
(1) Slide CATV/DVD-TV/VCR switch on the
(2) Press POWER on the VCR to ON.
(3) Stand at least six feet away from the front of
(4) Watch the Channel Number indicator on the
30
DVD/VCR
POWER
INPUT
DISPLAY
3
6
9
ENTER
100
D
VOL
+
CHANNEL
MUTE
UP (8)/
DOWN (9)
TV
VCR
CATV/DVD-TV/VCR
CH/SKIP
Some brands have more than one remote
code listed, due to changes in the remote
codes from early to later model years, or due
to format differences (VHS/BETA). In such
cases, you may have to try more than one code
to find the code your VCR accepts.
Depending on the model, year produced,
brand, and type of VCR, some models may
not be compatible with the remote control.
remote to VCR.
the VCR.
Point the remote towards the VCR.
Hold down DISPLAY and CH UP ( 8 ) at the
same time. KEEP HOLDING THE BUTTONS
DOWN.
VCR, Channel numbers will scan up when the
VCR has been identified.
Release DISPLAY and CH UP ( 8 ) as soon
as the channel numbers start to scan up.
The VCR's remote control code number has
been identified, and the remote is ready to
operate the VCR.
18/6/01, 4:05 pm

Advertisement

Table of Contents
loading

Table of Contents