Epson PowerLite 1725 Operation Manual page 88

Easy mp
Hide thumbs Also See for PowerLite 1725:
Table of Contents

Advertisement

Troubleshooting
f
EMP NS Connection cannot be used to make a connection
Check the message at the bottom-left of the screen and then apply the following countermeasures.
Error Messages
The application version used is not supported.
f
Sudden changes to the EasyMP screen
ERR at the bottom left of the screen: Check the numbers and make the following remedies.
ERR Number
2,50,53,245,-103
Failed to startup EasyMP.
51,52,100
Failed to process EasyMP.
-101
Communication was cut off from the access point.
-102,-105
Wireless communication is unstable.
When a connection is made using EMP NS Connection, the projected image remains as is, and a connection cannot be made from another
f
computer.
Check
Did the presenter leave the conference room without
cutting off the network connection?
You are using an old version of EMP NS Connection. A connection cannot be made. Install the current
version from the "EPSON Projector Software for Meeting & Presentation CD-ROM" supplied with the
projector.
Error Meaning
With EMP NS Connection, the connection with the computer that was previously connected can be cut off
when another computer tries to connect with the projector, and it connects with the computer that is trying to
connect.
Therefore, when a projector keyword is not set for the projector, or if you know the projector keyword, you
can cut off the current connection and, if you perform a connection operation, you can connect to the
projector.
When a projector keyword is set for the projector, if you do not know the projector keyword, cut off
projection from the projector and reconnect. To cut off connection from the projector, press the [Esc] button
on the remote control, select "Close" from the close menu and press the [Enter] button on the remote control.
When it cuts off, you can connect from the target computer.
Remedy
Remedy
Turn the power for the projector off and then back on again.
If you're using EMP NS Connection, restart EMP NS Connection.
If you're projecting via USB, reconnect the USB cable.
Check the access point operation.
Network traffic may be high. Wait a while, then try reconnecting.
Remedy
88

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents