Table of Contents
Advertisement
---------------------------------------------------------------------------------------------------------------------------------------------------- WINDOWS NT4.0
2.4
Windows NT4.0 Setup
2.4.1
Install the Modem Driver
1. Close all applications.
2. Choose Start > Settings > Control Panel.
3. Double click on Modems then click Add...
4. Choose the checkbox marked "Don't detect my modem; I will select it from a list." Then, click Next >.
5. From the Manufacturer list, highlight Iridium
6. Click Iridium PPP Data Modem, and then click Next>.
7. Click the "Selected ports" radio button. Click on an available COM Port (e.g., COM1). This is the port
to which you will connect your Iridium phone. Click Next >.
8. Click Finish.
9. Click OK, Close.
10. The Modem Setup window appears and asks if you would like to configure Dial-Up Networking. Click
Yes.
11. The Remote Access Setup window appears. Note: If a modem is already installed on the COM port
that you would like to use, select the modem in the list and click Remove.
12. Click Add and select the "Iridium PPP Data Modem" from the list of RAS capable devices. Click OK.
13. The new entry is added to the list of modems. Click Continue.
14. When asked if you would like to restart the computer, click Yes.
2.4.2
Configure Dial-Up Networking
1. Choose Start > Programs > Accessories > Dial-Up Networking. If Dial-Up Networking has no
"phonebook entries", you will be prompted to "Press OK to add an entry".
2. Click New...
3. In the Entry name box, enter a connection name (e.g., "Iridium Direct Internet 2.0").
4. In the Phone number box, enter 008816000025
5. Uncheck the "Use Telephony dialing properties" box.
6. In the Dial using list, select "Iridium PPP Data Modem"
7. Select the Server tab.
8. Make sure "TCP/IP" is checked and uncheck "IPX/SPX compatible", "NetBEUI".
9. Click OK, Close.
Iridium Satellite LLC
6
February 22, 2006
Advertisement
Table of Contents
