Download  Print this page

Install Reverse Osmosis Filter Assembly; Install Storage Tank - Kenmore 625.381560 UltraFilter 450 Owner's Manual

Reverse osmosis system
Hide thumbs

Advertisement

INSTALL REVERSE OSMOSIS FILTER ASSEMBLY
The Reverse Osmosis Filter Assembly
is mounted
on hang-
er washers. The hanger washers allow you to lift the filter
assembly
from the washers without
any hardware
removal.
When planning
your installation,
you need to
leave room for changing
filters.
See Figure 11.
Complete
the following
steps to install your Reverse
Osmosis Filter Assembly-
]. Remove the cover.
2. Locate mounting
slots on back of the assembly. See
Figure ]].
3. Hold the assembly
up to the wall surface
and mark
locations
for the hanger washers.
This allows
room to
change
filters.
4. Fasten the hanger washers to the wall using the wood
screws provided.
5. Hang assembly
on washers.
6. Replace
cover.
Hanger
Washe_
::
Screw
(2)
11
15-1/2" Minimum up
from floor. This distance
allows for space to
change
filters
Figure 11
INSTALL STORAGE TANK
1. Apply
thread
sealing
tape to the threads
on the nipple
at the top of the tank (max. 2 wraps).
See Figure 12.
2. Locate the tubing connector.
Tighten the tubing
connec-
tor with a wrench onto the tank nipple 7-8 turns, being
careful
not to cross thread
or overtighten.
See Figure 12
3. Do not connect the tube at this time. This will occur
later in the assembly.
4. Place the storage
tank next to the Reverse Osmosis
Assembly.
The tank can be placed
upright
or on its
side.
tank
nipple
\
//
//
/' /
s i
tubing
connector
ge tank
Figure 12
Questions?
Call
The
Kenmore
Water
Line 1-800-426-9345
or visit
KenmoreWater.com
11

Advertisement

loading

  Also See for Kenmore 625.381560 UltraFilter 450

  Related Manuals for Kenmore 625.381560 UltraFilter 450

This manual is also suitable for:

Ultrafilter 450