Cleaning Procedures - Maytag 8113P560-60 Rev. 1 User Manual

4. Press the A or V pad.
• CL-M (Clean - Medium Soil) is displayed. A
5. Press the A or V pad to scroll through the
self-cleaning settings. V
CL-H (Clean - Heavy Soil, 4 hours]
CL-M (Clean - Medium Soil, 3 hours]
CL-L (Clean - Light Soil, 2 hours]
Choosing the soil level of the oven automatically programs
the self-cleaning time.
6. After four seconds, CLEAN, DELAY and LOCK will appear
in the display to show that the oven is set for a delayed
clean operation. The delay time is displayed.
If the oven has already been set for a clean
cycle and you wish to set a delay:
1. Press the DELAY pad. DELAY
• DELAY flashes. ..........
• 00:00 will appear in the display.
Press the A or V pad to set the amount of time
you want to delay the cycle.
After four seconds, CLEAN, DELAY and LOCK will appear
in the display to show that the oven is set for a delayed
clean operation. The delay time is displayed.
When the Self=Clean cycle starts:
• DELAY will turn off.
• The clean time will appear in the display.
To cancel the Self=Clean cycle:
Press the CANCEL pad.
• All words disappear from the display.
° All functions are canceled.
° The time of day appears in the display.
During the Self=Clean Cycle
When LOCK shows in the display, the door cannot be opened.
To prevent damage to the door, do not force the door open
when LOCK is displayed.
Smoke and Smells
You may see some smoke and smell an odor the first few
times the oven is cleaned. This is normal and will lessen in
time.
Smoke may also occur if the oven is heavily soiled or if a
broiler pan was left in the oven.
Sounds
As the oven heats, you may hear sounds of metal parts
expanding and contracting. This is normal and will not
damage the oven.
After Self=Cleaning
About one hour after the end of the self-clean cycle, LOCK
will turn off. The door can then be opened. Move door lock
lever to the left to unlock.
Some soil may leave a light gray, powdery ash. Remove
it with a damp cloth. If soil remains after wiping, that means
the clean cycle was not long enough. The soil will be
removed during the next clean cycle.
If oven racks were left in the oven and do not slide
smoothly after a clean cycle, wipe racks and rack supports
with a small amount of vegetable oil to make them easier to
move.
Fine lines may appear in the porcelain because it went
through heating and cooling. This is normal and will not
affect performance.
A white discoloration may appear after cleaning if acidic
or sugary foods were not wiped up before the self=clean
cycle. This discoloration is normal and will not affect
performance.
Notes:
° If the oven door is left open, DOOR will flash in the
display and a signal will beep until the door is closed
and the CLEAN pad is pressed again.
• The oven door will be damaged if the oven door is
forced to open when LOCK is still displayed.
Cleaning Procedures
6
Broiler Pan and insert
Never cover insert with aluminum foil as this prevents the
fat from draining to the pan below.
• Place soapy cloth over insert and pan; let soak to loosen soil.
• Wash in warm soapy water. Use scouring pad to remove
stubborn soil.
° Broiler pan and insert can be cleaned in dishwasher.
Surface Burners = Conventional = Sealed
• Clean frequently. Allow burner to cool. Clean with soap and
plastic scouring pad. For stubborn soils, use a non-abrasive
cleaner and a cloth. Try to prevent the cleaner from seeping
into the gas ports as this will affect the flame. If the cleaner
does enter the ports, clean with a soft bristle brush or a
straight pin especially the port below the ignitor. Do not
enlarge or distort holes.
° Be careful not to get water into burner ports.
• Use care when cleaning the ignitor.If the ignitor is wet or
damaged the surface burner will not light.
• Conventional Burners: Dry burners in the oven set at 170° F.