Cycle Modifier Buttons - Kenmore 402.4903 Series Use & Care Manual

CYCLE MODiFiER BUTTONS
Each cycle has default settings that are selected automatically.
You may also customize these settings using the cycle modifier
buttons. Press the button for the desired modifier until the indicator
light for the desired value is lit.
The washer automatically adjusts the water level for the type and
size of wash load for best results and maximum efficiency. Due
to the high-efficiency nature of this product, water levels may be
much lower than expected. This is normal operation and cleaning/
rinsing performance will not be compromised.
Hot/Cold
Warm/Warm
Warm/Cold
Cold!Cold
High
Medium
Low
No Spin
Heavy
Normal
Light
A=
/ ................... ............. ] ...................... \.
Wash/R nse Spin Speed Soil Level ] Chime O j
WASH/RINSE
Selects the wash and rinse temperature combination for
the selected cycle. Press the WASH/RINSE button until the
indicator light for the desired setting is lit.
Your washer features a heating element to boost the hot
water temperature for Extra Hot settings. This provides
improved wash performance at normal water heater
settings.
Select the water temperature suitable for the type of load
you are washing. Follow the garment fabric care labels for
best results.
Warm rinses are regulated at approximately 86°F (30°C).
Warm rinses leave the clothes drier than cold rinses, but
will result in increased energy consumption and greater
wrinkling of clothes.
Cold rinses use less energy. The actual rinse temperature
depends on the temperature of the cold water at the faucet.
NOTE: To protect your garments, not every wash/rinse
temperature, spin speed, soil level, or option is available with
every cycle. A different chime will sound and the LED will not
come on if a selection is not allowed. See the Cycle Guide on
page 14 for details.
B=
C=
D=
SPiN SPEED
Higher Spin Speeds extract more water from clothes, reducing
drying time and saving energy.
Press the SPIN SPEED button until the indicator light for the
desired setting is lit. Some fabrics, such as delicates, require a
slower spin speed.
The Drain & Spin cycle:
1. If you press the POWER button and then press and hold the
SPIN button for 2 seconds, the spin time will be displayed
on the display panel.
2.Then, press the SPIN button repeatedly until the required
spin level is selected, and then press the START/PAUSE
button.
NOTE: Before pressing the SPIN ONLY button to use the Spin
Only function, you can select a cycle with the Cycle Selector.
If you have selected a cycle, you can only select the spin level
corresponding to the selected cycle.
SOIL LEVEL
Adjusts the selected cycle to allow more time for heavily soiled
clothes or less time for lightly soiled clothes.
Press the SOIL LEVEL button until the indicator light for the
desired setting is lit.
CHIME
Press the SIGNAL button to turn the signal on or off.
18
Kenmole-Washer-Ownels-Manual EN.indd 18 3,23,2010 3:12:25PM