5. Define Basic Network and HA Settings
Configure the Quorum Server
Configure the NAS Servers
The Quorum has a Linux operating system. Use standard Linux network procedures to assign
an IP address to the Quorum server using either DHCP or manual IP addressing.
Before you can access the Command View NAS web interface, you must configure the System
Management network port on both NAS servers.
Note
You will configure additional NICs using the Command View NAS web interface.
1.
Connect a laptop with terminal emulation software to the server.
Connect an RS232 null-modem cable to the Management Port on the server.
Figure 9
LT 6000r Server Management Port
2.
Use a terminal emulator to log in and enter network settings.
Use the following settings:
—
Bits per second: 9600
—
Data bits: 8
—
Parity: None
—
Stop bits: 1
—
Flow control: None
3.
Press Enter until you see the system name and login prompt, as shown here, then log in as
admin. No password is required.
hp nas8000
NAS OS v1.0.0
localhost login:admin
Installation Guide
33