Setting The Daily Timer - JVC RV-NB1 Instructions Manual

Setting the daily timer

Once the timer has been set, it will be activated at the same time
everyday until the timer is turned off. Recording timer works only
one time.
• While the timer is being set, the timer indicator (
• While the timer has been set, the timer indicator (
up if the power is supplied through the AC outlet.
• While the timer is working, the timer indicator (
Using the remote control only
I
1. Press ON/STANDBY.
I
2. Press CLOCK/TIMER.
"TIMER ON?" appears.
• Press SET to activate the timer setting you have made before.
• Press CANCEL to cancel the timer.
• Go to the next step to reset the timer (or set the timer first
time).
I
3. Press CLOCK/TIMER again, so that the
timer indicator (
up.
The hour digit of the current ON time blinks on the display.
I
4. Set the on-time you want the system to
turn on.
(1) Press ¢ or 4 to select the hour, then press SET.
(2) Press ¢ or 4 to select the minute, then press SET.
The OFF indicator lights up.
• Press and hold the button will change the time rapidly.
• If you want to change the time setting, press
CANCEL.
I
5. Set the OFF time (example: PM1:30).
(1) Press ¢ or 4 to select the hour, then press SET.
(2) Press ¢ or 4 to select the minute, then press SET.
• Press and hold the button will change the time rapidly.
• If you want to change the time setting, press
CANCEL.
) lights up.
) also lights
) blinks.
) and ON indicator light
I
6. Press ¢ or 4 to select the music source
you want to listen to, then press SET.
Each time you press the button, the display changes as shown
below:
\
TUNER = TU TAPE = CD = TAPE = (back to the
beginning)
\
When you select the "TU
• The REC indicator appears on the display.
• The timer will be canceled after tuner recording has been
finished.
I
7. Press ¢ or 4 to select the volume level,
then press SET.
– – : The current volume level will be used.
0 to 50 : When the timer is turned on, the volume will be
automatically set to the selected level.
• The current timer setting appears for confirmation.
I
8. Before turning off the system, prepare the
music source selected in step
TUNER
: Tune into the desired station.
\
TU TAPE : The last tuned station will be recorded. Insert a
cassette tape for recording the station.
CD
: Set a disc.
TAPE
: Insert a tape.
I
9. Press ON/STANDBY to turn off the
system.
• When the timer turns on, the volume level gradually increases
from 0 (zero) to the preset level in step
However, if the volume has been set to "– –", the volume
level will be set to the last level directly.
To cancel the operation, press CLOCK/TIMER until the
display returns to the original one.
To cancel the timer, press CLOCK/TIMER once, then press
CANCEL. ("TIMEROFF" appears, only when power is on.)
To reactivate (or confirm) the canceled timer, press
CLOCK/TIMER once, then press SET. (The current timer setting
appears for confirmation.)
Notes:
• The timer cannot be set if on-time and off-time are the same.
• The timer does not work if the system is not in the standby mode
(the system needs to be in standby mode at least one minute
before the on-time).
CAUTION: If memory backup batteries are
exhausted or not installed, and the AC power
cord is disconnected or there is a power failure,
time settings will be erased from memory. If this
happens, set the current time (clock) and
perform the timer setting again.
TAPE";
.
6.
.
7.
18