Playing Back Tapes; Regular Play; Reverse Mode - JVC RV-NB1 Instructions Manual

I I

Playing back tapes

4
REVERSE
MODE
With automatic tape direction, you can listen to type I or II tapes
without having to change any settings.
The use of tapes longer than 120 minutes is not recommended,
since characteristic deterioration may occur and these tapes
easily jam in the pinch-rollers and the capstans.

Regular play

I
1. Turn the LOCK/RELEASE knob
counterclockwise to open the cassette
holder.
I
2. Put the cassette in, with the side you want
to listen facing you.
I
3. Close the holder gently and turn the knob
to "LOCK" position.
I
4. Press TAPE 2 3.
The tape is played in the direction shown by the tape direction
indicator.
3 (Forward playback): The side of the tape facing you is
played back.
2 (Reverse playback): The opposite side of the tape is
played back.
13
7
¢
TAPE 2 3
LOCK/RELEASE
knob
4
TAPE 2 3
I
5. If you need to change the playback
direction, press TAPE 2 3.
The opposite side tape direction indicator lights up and the tape
playback direction changes.
To stop playing, press 7.
To remove the tape, stop the tape, and open the cassette
holder by turning the LOCK/RELEASE knob to the
"RELEASE" position.
Notes:
• Do not turn the LOCK/RELEASE knob during playback.
• When no tape is loaded in the deck, "NO TAPE" appears on
the display.
To fast-wind/rewind a tape
Press ¢ or 4 to fast-wind/rewind the tape.
• The cassette deck automatically stops when the tape reaches its
end.

Reverse mode

You can set a tape to play just one side, both sides in succession, or
both sides continuously.
Using the remote control
Press REVERSE MODE.
Each time you press the button, reverse mode indicator changes as
follows:
= = = (back to the beginning)
: The cassette deck automatically stops after playing
one side of the tape.
: The cassette deck automatically stops when playback
in the reverse (2) direction is finished.
: The cassette deck continues to play both sides of the
tape until the 7 button is pressed.
¢
7