Download  Print this page

Kenmore 625.385010 Owner's Manual page 8

Advanced two-stage drinking water fiter
Hide thumbs

Advertisement

CONNECT
YELLOW
TUBE TO WATER SUPPLY
FITTING
1. Locate the yellow tube.
One end is attached
to the fil-
ter housing.
Run the other end to the water supply fit-
ting on the cold water pipe. See Figure 8.
2. Refer to the "Cut Tubes to Length"
section, below, and
cut the yellow tube square
and to length as needed.
3. Refer to the "Connect
Tubes" section, below, and
insert the yellow tube all the way into the 3/8" quick
connect fitting on included
water supply
fitting
(installed
in Step 1).
4. Pull on the tube to be sure it is held firmly in the fit-
ting.
HOW
TO CUT AND
CONNECT
THE TUBES
Your Advanced
Two-Stage
Drinking
Water Filter
includes
push-in
fittings for quick tubing
connection.
Review the following
before connecting
the tubes.
Cut tubes
to length
1. Use a sharp cutter or knife to cut the end of tubing.
Always
cut the tubing square. See Figure 9.
2. inspect
the end (about 1") of the tubing to be sure
there are no nicks, scratches
or other rough spots,
if
needed,
cut the tubing again.
Connect
tubes
1. Push tubing through
collet, until it engages
the o-ring.
See Figure
10. Continue
pushing
until the tube bot-
toms out against
the back of the fitting.
See Figure 11.
A common
mistake is to stop pushing
when the tube
engages
the o-ring.
This will lead to future leaks.
When a 3/8" tube is fully engaged,
3/4" of the tube has
entered
the fitting.
See Figures 10 & 11.
2. if using tubing other than tubing supplied
with the
system, be sure it is of high quality, exact size and
roundness
with a smooth
surface.
Disconnect
Tubes
1. Push the collet inward
with a finger tip. See Figure
12.
2. Continue
holding
collet inward
while pulling
the tub-
ing out. See Figure 13.
cold water
supply
fitting
yellow
(_))
tubing
cold water
filter
_..-_
shutoff
housing
Push In Fitting
Tube
NN4 K
Cut tubing
square
with end of tubing round,
smooth,
with no cuts, nicks or flat spots.
Tube Correctly
Cut
O-Ring
f
Tube Partially
Engaged
With Fitting
O-Ring
Tube Fully Engaged
With Fitting
®
Figure
8
Figure
9
Figure
10
Figure
11
Collet (Depress
to
Remove
Tubing)
-"-_1_ (
_-"_
Tubing
Figure
13
Disconnect
Tubing
Figure
12
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com

Advertisement

Table of Contents
loading

  Related Manuals for Kenmore 625.385010

This manual is also suitable for:

Elite 625.385010