Advertisement
TURN OFF WATER SUPPLY
LEVEL IF NECESSARY
1. Close the main water supply valve, near the well
pump or water meter.
2. Open all faucets to drain water from the house
pipes.
NOTE: Be sure not to drain water from the water
heater, as damage to the water heater ele-
ments could result.
MOVE THE CENTRAL
WATER
FILTRATION
SYSTEM
INTO PLACE
1. Move the Central Water Whole Home Filtration
System into installation position.
Set it on a level
surface.
If needed, place the unit on a section of
plywood, a minimum of 5/8" thick. Then place
shims under the plywood to level the Central Water
Filtration System (see Figure 4).
Shim(s)
Plywood
/
Figure 4
CROSS OVER
In what direction
does the water flow?
Be sure to plan piping so water flow is to the
Central Water Whole Home Filtration System
valve INLET. Plan a crossover if flow is from
left to right.
Main
---_
WaterPipe
Treated
Water from
Valve
OUTLET
t
Untreated
Water to
Valve
INLET
To Central
Filtration System
Figure 5
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
Advertisement
