Advertisement
SETTING
THE FREQUENCY
OF AUTOMATIC
CLEAN
RINSE
CYCLES
The Central Water Whole Home Filtration System will automatically initiate
Clean Rinse cycles based on how much water has been filtered through the
system. The default is to run a Clean Rinse cycle after 3000 gallons have
been filtered.
The Clean Rinse cycle takes place at the preset time of day
(1:00 a.m. is the default). The system also will initiate an automatic Clean
Rinse cycle if no water has been run through the system in 14 days, to keep
the filter bed fresh.
The Central Water Whole Home Filtration System allows the frequency of
automatic Clean Rinse cycles to be increased for systems where the water
supply may have more sediment than in a typical municipal water supply.
The table below shows the three settings available.
The unit is shipped with
"CLn 1" as the default.
Clean
Rinse
Clean
Rinses
mode
Water
supply
type
every
CLn 1
City water supply
3000 gallons
Well water with a
CLn 2
light amount of sediment
2000 gallons
Well water with a
CLn 3
high amount of sediment
1000 gallons
To change the frequency of Clean Rinse cycles:
1. Press the ENTER button a few times until "SET CLn" is shown in the dis-
play, along with a flashing number (1 - 3). The flashing number indicates
the current setting.
2. Press the /X UP or V DOWN buttons to change the number to the
desired Clean Rinse mode (see table, above).
3. Press the ENTER button when the desired Clean Rinse mode is dis-
played. The display will change to the time of day.
-SET
r!
LLI-I
!
-SET
If-!
ILLN
2
-SET
r!
LLI-!
Figure 17
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
15
Advertisement
