General Maintenance - Craftsman nextec 320.61325 Operator's Manual

4. After you complete the cut, release the trigger switch and allow the blade to
come to a complete stop. After the blade has stopped, remove it from the
workpiece. If the corners of your pocket cut are not completely cut through,
use a hand finishing saw to finish the corners.
,_ WARNING: Never tie the lower blade guard in the raised position. Leaving
the blade exposed could result in serious injury.
,_ WARNING: When servicing, use only identical Craftsman replacement parts.
Use of any other parts may create a hazard or cause product damage.
WARNING: Always wear safety goggles or safety glasses with side shields when
using compressed air to clean tool. If the operation is dusty, also wear a dust mask.
,_, WARNING: To avoid serious personal injury, always remove the battery
pack from the tool when cleaning or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible
to damage from various types of commercial solvents and may be damaged by
their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
,_ WARNING: Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
Only the parts shown in the parts list are intended to be repaired or replaced by
the customer. All other parts should be replaced at a Sears Service Center.
CHANGING THE BLADE (Fig. 22)
Fig. 22
Spindle lock button
WARNING: Be sure to wear protective work gloves while handling a saw
blade. The blade can injure unprotected hands.
61325 Manual_Revised_lO 0225 Page 30