Download Print this page

General Maintenance - Craftsman 315.108620 Operator's Manual

7-1/4 in. circular saw with laser guide double insulated
Hide thumbs

Advertisement

_)'
WARNING:
When servicing, use one,' }dentica}
Craftsman replacement parts. Use of any other parts
may create a hazard or cause product damage.
A
WARNING: Alwayswear safety goggles or safety
glasses with side shields dudng power tool operation
or when blowing duel If operation is dusty,also wear
a dust mask.
GENERAL MAINTENANCE
Avoid uslngsolvents whet] cleaningplast)cparts.Most
plastics are susceptible to damage from various types of
commercia}solvents and may be damagedby their use.
Use clean cloths to remove dirt, dust, o11, grease,etc.
_ll, WARNING: Do not at any time let brakefluids,
gasoline, p etroleum-based products, p enetrating
oils,etc., comein contact with plasticparts°
Chemicals can damage, weaken or destroyplastic
which may result In serious personal injury.
Electric toots used on tibergtass material, wallboard,
spacPJ{ng compounds, or plaster are subject to
accelerated wear and possible premature failure because
the fiberglass chips and gdnd[ngs are highly abrasive to
bearings, brushes, oommutators, etc.. Consequent_, we
do not recommended us)rig this too} for extended work on
these types of materials. However, ff you do work with any
of these materials, it is extremely important to clean the
tool using compressed air.
LUBRICATION
A)] of the bearings in thistoo_ are lub_cated witha
sufficient amount of high grade Jubricantfor the life of
the unit under normal operating conditions. Therefore,no
further lubrication is required.
Onlythe pads shown on the parts list are _ntendedto
be repairedor rep}aced by the customer. A It other parts
should be replacedat a SearsService Center.
22

Advertisement

loading

  Related Manuals for Craftsman 315.108620