A
WARNING:
Before performing any adjustment,
remove blade from saw. Failure to do so could result
in possible serious personal injury,
A
WARNING: DO NOT point the laserat yourself
or others,Class Ilia lasers willbum the retinas and
could cause sedous injuryto the eyes.
A
CAUTION:
Use of controls or adjustments or
performance other than those specified herein may
result in hazardous radiation exposure,
ADJUS'NNG
THE REAR LASER
See Figures 24 - 25.
NOTE: The rear laser is the only laser on the tool designed
to be realigned.
The rear laser can be realigned by adjusting the two
screws located in the back of the upper blade guard. The
top screw moves the laser beam laterallyfrom left to right.
The bottom screw moves the laser beam in a rotational
direction°
NOTE: Draw a pencil line on scrap workpiece parallel to
the long edge of the base as a stralght line guide to atd in
the adjusting process,
[] Remove the blade, dust nozzle, and dust nozzle adap-
tor if installed.
I
Plug in the saw.
[] Turn laser on.
[] Rest the back of the base on scrap workpiece.
[] Adjust screws as necessary.
I
Stnce blade thicknesses vary, always make a trial cut In
scrap workplace to ensure an accurate cut,
[] Check for proper alignment.
[] Repeat as necessary until laser is aligned.
REMOVE DUSTKNOZZLE
\
\iS/N
.
t
I
lop i
Fig. 25
21