Craftsman Lithium 320.28127 Operator's Manual page 18

TO ATTACH BATTERY PACK (Fig, 5)
1. Align the raised portion on the battery pack with the grooves on the rear of
the sabre saw, then attach the battery pack to the tool as shown,
2. Make sure the latch on the battery pack snaps into place and that the batter,/
pack is secured to the saw before beginning operation°
TO DETACH BATTERY PACK (Fig. 5)
1. Press the latch located on the front of the battery pack to release battery pack.
Pull forward on the battery pack to remove it from the saw.
2,
,4_ WARNING: Battery
tools are always in operating
condition. Therefore, the trigger
switch should always be locked
when not in use or when carry-
ing the tool at your side.
TRIGGER SWITCH (Fig. 6)
To turn the saw ON, push
the lock-off button to left side
then depress tdgger switch.
14
To turn it OFF, release the
trigger switch and push the
lock-off button to right side
to lock the trigger switch.
Fig, 5
2_
l'; :i' ,C ,lil Fj
½: ,_u ,j.j
NOTE: The lock-off button can be activated when the trigger is released.
VARIABLE SPEED (Fig. 6)
The variable speed trigger switch delivers higher speed with increased trigger
pressure and lower speed with
decreased trigger pressure°
Fig_ 6
Lock-off Bu_on
Trigger Switch
28127 Manual_Revised 07-0320 Page 18