Setting A Password; Turning On The Password And User's Logo - Epson PowerLite 54c User Manual

Setting a Password

1. Press the button on the remote control for about 7
Freeze
seconds, until you see the Password Protect menu:
2. Select and press
Password
the password?
3. Select and press
Yes
4. Enter a 4-digit password using the numeric keypad on the remote
control.
The password will be displayed as
digit, a confirmation screen appears. Enter the password again.
5. After you finish setting the password, press the
return to the Password Protect menu.
Make a note of the password and keep it in a safe place in case you
forget it.

Turning On the Password and User's Logo

1. To enable the password, select
. Select then press
Enter ON
2. If you want to disable the password temporarily, select
press . Then use the numeric keypad to enter the number of
Enter
hours (from 0 to 999) that you want the password feature
disabled. If you want the projector to request the password every
time it is turned on, set the timer to
The countdown for the elapsed time begins as soon as you close
the Password Protect menu. (You can check the elapsed time in
this menu next to
. You see the message
Enter
.
Enter
. After you enter the last
****
Power ON Protect
.
Esc
.
0H
.)
Time elapsed
note
If a password has already
been set, you see the
Password Protect Release
screen. See "Starting the
Projector with a Password"
on page 60.
Change
button to
Esc
and press
and
Timer
Fine-tuning the Projector
Use these buttons like a
numeric keypad to enter
the password
59