Adjusting the Image Shape
The projector automatically corrects images that are distorted when
the projector is tilted up or down (up to a 15° tilt). The Keystone
window appears on the screen while the projector makes the
correction. If the projected image still isn't rectangular or has a
"keystone" shape, do one or more of the following:
If your image looks like
projector off to one side of the screen, at an angle. Move it directly
in front of the center of the screen, facing the screen squarely.
If your image looks like
may have been disabled or you may need to manually adjust the
keystone correction value. (Auto Keystone is not available when
you're using ceiling or rear projection.) Follow the directions
below:
To turn on Auto Keystone, press the
remote control. Use the
menu, then press
Setting
press
to highlight this option and press
the Auto Keystone window that appears and press
save your changes. Exit the menu by pressing the
button.
To manually adjust the keystone correction value, press the
or
side of the
correct the shape of the image. After correction, your image
will be slightly smaller.
You can also make keystone adjustments using the projector's Setting
menu. See page 52.
or
, you've placed the
or
, the Auto Keystone feature
button on the
Menu
directional button to select the
. If
Enter
Auto Keystone
Enter
button on the projector to
Keystone
Menu
is
,
OFF
. Select
in
ON
to
Enter
Menu
Enter
Using the Projector
Directional buttons
35